
EV Charger Installation

EV Charger Installation in Southern Maine
Charge your electric vehicle at home overnight. Aces Highlands HVAC-Plumbing-Electrical installs Level 2 EV chargers and Tesla Wall Connectors for homes throughout Greater Portland and Southern Maine — sized, wired, and inspected for safe, reliable charging.

Our licensed electricians pull permits and arrange inspections when the work requires them.
Call now to schedule EV charger installation: (207) 670-8616



EV Charger Installation
A Level 2 charger adds roughly 25 to 30 miles of range per hour, so you wake up to a full battery every morning. We install Tesla Wall Connectors, ChargePoint, JuiceBox, and other universal connectors, running a dedicated 240-volt circuit from your panel to the garage or driveway with clean conduit and proper circuit protection.
- Level 2 Home Chargers
- Tesla & Universal Connectors
- Wired Safely to Code
To schedule EV charger installation, call (207) 670-8616.
Electrical Services We Provide
More capacity, and replacing older panels with a documented safety history (Federal Pacific, Zinsco).
Dealing with knob-and-tube or aluminum branch circuits, or running new circuits for a remodel.
New circuits, GFCI/AFCI code compliance, tamper-resistant devices.
Recessed, outdoor, and smart lighting, done to the right fixture rating for the location.
A dedicated 240-volt circuit sized under NEC Article 625.
Standby power with a code-compliant automatic transfer switch.
Electrical Repair & Troubleshooting
Flickering lights, warm outlets, nuisance tripping, and everything that falls under "something's not right."
Level 1 vs. Level 2 Charging: What Is the Real Difference?
Level 1 is the cord that came with your car plugged into a standard 120-volt outlet — it adds roughly 3 to 5 miles of range per hour, which means a full day and night to recover a long commute. Level 2 runs on a dedicated 240-volt circuit and adds about 25 to 30 miles per hour, turning any overnight into a full battery. For most Maine EV owners, Level 2 at home is the difference between owning an EV comfortably and planning your life around public chargers — especially in winter, when cold-weather range loss makes overnight recovery matter more.
There is also a safety point worth stating plainly: EV charging is a sustained multi-hour load, the most demanding thing most home circuits will ever do. Chargers plugged into worn dryer outlets or wired on undersized circuits are a documented fire pattern nationally. A dedicated, properly protected circuit installed by a licensed electrician is not gold-plating — it is the correct way to do this.
How Much Does EV Charger Installation Cost in Greater Portland?
Includes the charger; the run from your panel to the charger location, wire gauge, and whether the panel needs a new breaker or a full upgrade move the price.


What Does EV Charger Installation Cost — and Will Your Panel Handle It?
Nationally, a Level 2 home installation typically runs $800-$2,000 including the charger, with the biggest variables being the distance from your panel to the charger location and whether panel work is needed. A 48-amp charger needs a 60-amp circuit, so homes with 100-amp service or a full breaker panel often need a panel upgrade first — or a load-management approach, where a lower-amperage charger fits your existing capacity. We run the load calculation and give you both options with real numbers, because as a local shop we would rather right-size your project than maximize the invoice.
Efficiency Maine and some utilities have offered incentives on home EV charging equipment, and federal tax credits have applied to installation costs in recent years — we will point you to what is current when we quote your project.
- Includes the charger
- The run from your panel to the charger location
- Wire gauge
- Whether the panel needs a new breaker or a full upgrade
Call (207) 670-8616 to schedule EV charger installation.

About EV Charger Installation
Most EV charger installations require available capacity at your service panel. If your panel is full or still at 100 amps, our panel upgrade service brings it up to 200 amps so it can safely handle the added load. We pull permits and coordinate inspection so your installation is fully code-compliant.
We help you choose the right charger and amperage for your vehicle and driving habits, then mount and wire it for years of dependable use. We offer financing options to make your installation more affordable, and we handle any related wiring upgrades at the same time.

When to Call an Electrician Right Away
You should call an electrician right away if you notice:
- Burning smell or scorch marks at the panel or an outlet
- Sparking, buzzing, or crackling from a panel or outlet
- Breakers that trip repeatedly or will not reset
- Partial power loss not caused by the utility
- Exposed, damaged, or overheating wiring
A burning smell, sparking outlet, or hot panel is a fire hazard — stop using the affected circuits and call us immediately.
Home EV Charger Installation: The Electrical Side
An EV charger install is a small job on paper — one circuit, one device — but it's governed by its own section of the National Electrical Code and it's usually the single biggest new load a Maine home has added to its panel since central air. Here's what actually goes into sizing and permitting one.
NEC Article 625 and the 'Continuous Load' Rule
Electric vehicle supply equipment has its own dedicated article in the National Electrical Code — Article 625 — because EV charging is treated as a continuous load, meaning it can run at full draw for three hours or more without a break. Continuous loads are required to be calculated at 125% of their rating when sizing the breaker and wire, which is why a 40-amp charger typically needs a 50-amp circuit, not a 40-amp one.
This is the detail that trips up a lot of DIY and unlicensed installs — the charger's nameplate amperage and the circuit it needs to sit on legally are two different numbers.
Does Your Panel Have the Room?
A Level 2 charger typically pulls a dedicated 40 to 60 amp, 240-volt circuit — a real chunk of most Maine homes' remaining capacity, especially a 100-amp service that also has to cover a heat pump, an electric range, or a well pump. We run a load calculation on the actual panel rather than assuming it fits, and we tell you up front if a panel upgrade needs to happen first.
Homes with a 200-amp service usually have room for one charger without other changes; a 100-amp service running electric heat frequently does not.
Tesla Wall Connector
The Wall Connector's single LED ring tells you its state without opening an app. A steady or slow-breathing white/blue light means it's powered and idle; solid green means a car is plugged in and charging is either active or scheduled; blue patterns during setup mean it's in Wi-Fi pairing mode. A blinking or solid red light is the one that matters — it means a fault, and the Tesla app (or the installation manual's LED troubleshooting table) has the specific blink-count meaning for that fault.
ChargePoint Home Flex
ChargePoint's ring light runs blue for normal operation — solid blue when it's connected to your network and ready, pulsing blue while a car is actively charging. Amber or red generally means the unit wants attention: check the ChargePoint app first, since it will usually name the specific alert (a scheduling hold, a connectivity drop, or a fault) rather than making you guess from the color alone.
Emporia EV Charger
Emporia's charger uses a ring light around the connector holster — green for normal ready/charging states, with the Emporia app providing the plain-language explanation behind any color change. As with the other two, a steady fault-colored ring is a sign to check the app before unplugging and trying again, not a reason to keep cycling the breaker.
When a Fault Follows a Breaker Trip
Permit, Inspection, and Placement
Like any new circuit, an EV charger install in Maine gets a permit and an inspection through the same electrical licensing process as a panel upgrade. We also plan the physical location with the cable's real reach and your parking pattern in mind — a charger mounted for the wrong side of the driveway is a surprisingly common complaint we get called to fix on someone else's install.
Sources: Maine Office of Professional Licensing — Electricians; Efficiency Maine — Off-Peak Charger Incentive


Why Choose Aces Highlands for EV Charger Installation in Greater Portland
We treat electrical work with the seriousness it deserves — whether it is a single home outlet or a full panel upgrade.
- Every connection is tight
- Every circuit is tested
- Our licensed electricians pull permits and arrange inspections when the work requires them
Safe, clean, and done right.
EV Charger Installation FAQ

Proudly Serving Greater Portland and Southern Maine
EV charger installation services available in:
• Portland • South Portland • Scarborough • Westbrook • Gorham • Falmouth • Cape Elizabeth • Cumberland • Windham • Standish • Gray • New Gloucester • Raymond • North Yarmouth • Yarmouth • Freeport • Pownal • Bridgton • Brunswick • Harpswell
If you don’t see your area listed, call (207) 670-8616 — chances are we can still help.

What Our Customers Are Saying
Trusted by homeowners across the Greater Portland area for quality workmanship, responsive service, and professional care.
Need EV Charger Installation Today?
Panel upgrades, EV chargers, generators, wiring, and lighting for your home — done safely and to code by a licensed Maine electrician.
Call now to schedule EV charger installation: (207) 670-8616