
Panel Upgrades

Electrical Panel Upgrade in Southern Maine
An outdated or undersized electrical panel can be a safety hazard and limit what your home can handle. Aces Highlands HVAC-Plumbing-Electrical upgrades residential panels to meet modern demands — from EV charger circuits to heat pump installations — across Portland, South Portland, Scarborough, Westbrook, Gorham, and Greater Portland.

Our licensed electricians pull permits and arrange inspections when the work requires them.
Call now to schedule an electrical panel upgrade: (207) 670-8616



Electrical Panel Upgrades
Many older homes in the Portland area still have 100-amp panels or outdated fuse boxes that cannot support modern electrical loads. We upgrade panels to 200-amp service, replace Federal Pacific and Zinsco panels, and install new breaker panels that meet current electrical codes. A 200-amp service is the standard for today's homes — it gives you the headroom to run an EV charger, a heat pump, central air, and an electric range all at once without nuisance trips or overheating.
- 100 to 200-Amp Upgrades
- Breaker Replacement
- Code Compliance
To schedule an electrical panel upgrade, call (207) 670-8616.
Electrical Services We Provide
More capacity, and replacing older panels with a documented safety history (Federal Pacific, Zinsco).
Dealing with knob-and-tube or aluminum branch circuits, or running new circuits for a remodel.
New circuits, GFCI/AFCI code compliance, tamper-resistant devices.
Recessed, outdoor, and smart lighting, done to the right fixture rating for the location.
A dedicated 240-volt circuit sized under NEC Article 625.
Standby power with a code-compliant automatic transfer switch.
Electrical Repair & Troubleshooting
Flickering lights, warm outlets, nuisance tripping, and everything that falls under "something's not right."
Why Older Maine Homes Are Stuck at 60 or 100 Amps
Homes built before the 1980s in Greater Portland were commonly wired for 60-amp or 100-amp electrical service, which was plenty for a house with an oil furnace, a few lights, and a refrigerator. It is not plenty for a house that also wants central air, an induction range, a heat pump, and a Level 2 EV charger.
The symptom shows up as breakers that trip when two big appliances run at once, or a panel that is already full of double-tapped breakers because there was no room left for a legitimate new circuit. Neither is something to work around — both are reasons to have the service sized up front rather than patched.
How Much Does an Electrical Panel Upgrade Cost in Greater Portland?
Meter and service-entrance condition, grounding upgrades, and how many circuits transfer to the new panel move the price; a like-for-like Federal Pacific or Zinsco replacement at the same amperage usually costs less.


How Much Does a 200-Amp Panel Upgrade Cost?
A typical 100-to-200-amp panel upgrade nationally runs in the $2,500-$4,500 range, with the final number depending on meter and service-entrance condition, grounding upgrades, and how many circuits transfer to the new panel. Replacing a hazardous Federal Pacific or Zinsco panel like-for-like at the same amperage usually costs less. We give you a firm written quote after seeing the panel — and because Aces Highlands HVAC-Plumbing-Electrical is a locally owned Portland company rather than a franchise, our price reflects the actual work, not a national brand fee.
One more honest note: if your panel is genuinely fine and your problem is a single overloaded circuit, we will tell you that too. A new dedicated circuit costs a fraction of a panel upgrade, and our electricians do not earn commissions for selling you the bigger job.
- Meter and service-entrance condition
- Grounding upgrades
- How many circuits transfer to the new panel
- A like-for-like Federal Pacific or Zinsco replacement at the same amperage usually costs less
Call (207) 670-8616 to schedule an electrical panel upgrade.

About Panel Upgrades
There are clear signs you have outgrown your panel: breakers that trip often, lights that flicker when an appliance kicks on, a fuse box instead of breakers, or no open slots left to add a circuit. Federal Pacific (FPE Stab-Lok) and Zinsco panels are a special concern — their breakers are known to fail to trip during a fault, which is a real fire risk, and many home insurers in Maine now require them to be replaced. If your panel is warm to the touch, rusted, or has scorch marks, treat it as urgent.
A panel upgrade is often required before adding major appliances, EV chargers, heat pump installations, or finishing a basement. We handle the full scope — pulling the permit, coordinating the service disconnect and reconnect with Central Maine Power, installing the new panel and meter base, transferring every circuit, and scheduling the municipal inspection. A typical 100-to-200-amp upgrade is a one-day job, and we keep your downtime to a few hours.
Every panel upgrade is performed by a Maine-licensed electrician and includes proper grounding, bonding, surge consideration, and clear circuit labeling. We test all circuits before we leave and walk you through your new panel so you know where everything is. While the panel is open, it is also the right time to address any outdated wiring in your home. Financing is available, and every estimate is free — contact us to schedule.

When to Call an Electrician Right Away
You should call an electrician right away if you notice:
- Burning smell or scorch marks at the panel or an outlet
- Sparking, buzzing, or crackling from a panel or outlet
- Breakers that trip repeatedly or will not reset
- Partial power loss not caused by the utility
- Exposed, damaged, or overheating wiring
A burning smell, sparking outlet, or hot panel is a fire hazard — stop using the affected circuits and call us immediately.
Panel Upgrades: What Southern Maine Homeowners Should Know
Most electrical panel calls we get start the same way: a homeowner wants an EV charger, a heat pump, or a hot tub, and the panel that came with the house has nothing left to give. Here's the background we'd want you to have before that conversation with an electrician.
None of this replaces a real load calculation on your own house — it's the context that makes that calculation make sense.
Two Panel Brands With a Real Safety History
If your panel is original to a house built roughly between the 1950s and 1980s, it's worth knowing what's behind the cover before anyone touches it. Federal Pacific Electric (FPE) panels with Stab-Lok breakers, and Zinsco panels, both have a documented history of breakers that fail to trip during an overload or short — the opposite of what a breaker is supposed to do. This is not a brand-loyalty opinion; it's been studied and reported on for decades by electrical safety researchers and insurers.
We don't scare-tactic every old panel into a replacement, but if yours carries either name on the cover, a full panel swap is the standard recommendation, not a patch.
100-Amp vs. 200-Amp Service
200 amps is the standard new-construction service size in Maine today, and it's what we size most upgrades to unless there's a specific reason to go smaller or larger (a small condo unit, or a home doing serious electrification with a generator, might land somewhere else). A 200-amp panel gives headroom for a heat pump, an EV charger, and future additions without a second upgrade five years later.
The upgrade touches more than the panel itself: the service-entrance cable from the weatherhead, the meter socket, and the grounding electrode system all get inspected and often replaced together, since the whole chain has to be rated for the new capacity.
Permits, Inspection, and Why That Matters at Resale
Electrical work in Maine, including a panel change, requires a permit pulled by a licensed electrician and a follow-up inspection through the Office of Professional Licensing's Electricians' Examining Board. We pull the permit and schedule the inspection as part of the job — it's not an add-on.
That paperwork matters later. A panel upgrade without a permit on file is a common flag in a home inspection when the house eventually sells, and it can complicate insurance claims if there's ever an electrical fire, whether or not the wiring itself was the cause.
Sources: Maine Office of Professional Licensing — Electricians; Maine Electrical Permits & Licensing


Why Choose Aces Highlands for Panel Upgrades in Greater Portland
We treat electrical work with the seriousness it deserves — whether it is a single home outlet or a full panel upgrade.
- Every connection is tight
- Every circuit is tested
- Our licensed electricians pull permits and arrange inspections when the work requires them
Safe, clean, and done right.
Panel Upgrades FAQ

Proudly Serving Greater Portland and Southern Maine
Electrical panel upgrade services available in:
• Portland • South Portland • Scarborough • Westbrook • Gorham • Falmouth • Cape Elizabeth • Cumberland • Windham • Standish • Gray • New Gloucester • Raymond • North Yarmouth • Yarmouth • Freeport • Pownal • Bridgton • Brunswick • Harpswell
If you don’t see your area listed, call (207) 670-8616 — chances are we can still help.

What Our Customers Are Saying
Trusted by homeowners across the Greater Portland area for quality workmanship, responsive service, and professional care.
Need Panel Upgrades Today?
Panel upgrades, EV chargers, generators, wiring, and lighting for your home — done safely and to code by a licensed Maine electrician.
Call now to schedule an electrical panel upgrade: (207) 670-8616